Hardware Overview
What is inside an FM-1, as far as the community knows. Each line has its tag (see Home).
The chip
| Tag | ||
|---|---|---|
| SoC | JieLi AC791N, WL82 family (“AC79” in JieLi’s SDK). The r/MVaveFM1 thread names the part AC79118B; the FM-1 resource hub reads AC7911B, QFN-48, marking JL C156211-11A-B, from board photos. Neither is checked here [?] (Open Questions). Strings like JL-BR22 in the stock firmware come from linked libraries and do not identify the chip. | [RE] [SDK] |
| CPU | JieLi pi32v2, 32-bit, little endian, 16-bit instruction words. Toolchain target -mcpu=r3. | [SDK] [CODE] |
| Cores | Two. The SDK defines CPU_CORE_NUM 2. Several firmwares run work on the second core. See Second Core. | [SDK] [HW] |
| FPU | Single-precision hardware floating point, enabled with -mfprev1. Doubles are done in software (slow). | [SDK] [CODE] |
| Caches | I-cache and D-cache (SDK). Size and layout: see Performance and Open Questions. | [SDK] [?] |
| Clock | 360 MHz under M-VAVE’s bootloader (measured); 320 MHz under m-bootloader 1.2 unless the firmware resets it. The SDK calls 320 MHz its maximum. See Clocks and Power. | [HW] |
| SRAM | The SDK says 578 KB of on-chip SRAM in total. Firmwares use the window 0x01C00000–0x01C80000 (512 KB). There is no external RAM on the FM-1. | [SDK] [CODE] |
| Accelerators | Hardware FFT/IFFT and matrix maths, AES-128/256, SHA, random numbers, CRC16 (SDK). Only CRC16 is known to be used by community firmware. | [SDK] |
| Radio | WiFi 802.11b/g/n and Bluetooth 5.0 (dual mode), on JieLi’s closed libraries. fm1-base supports BLE MIDI or WiFi (not both at once). | [SDK] [HW] |
The board
| Tag | ||
|---|---|---|
| Flash | 1 MiB SPI NOR, executed in place (XIP) through the SFC. JEDEC ID 856014: the only ID fm1_rescue accepts, so at least the units it was tested on have it. Chip key 0x980F on known units. | [HW] |
| Flash part | JEDEC manufacturer 0x85 is Puya; the hub names the Puya P25Q80H (8 Mbit) and says the die is inside the SoC’s package (SiP), wired to the SFC on PD0, PD1, PD4, PD5, PD6. Other notes speak of a SOIC-8 part on the board (Flash Storage). | [?] |
| Screen | 240×240 colour TFT, ST7789-class, RGB565, on SPI1. Backlight on PA2 (active low). See Display. | [HW] |
| Keys | 27 note keys (F3 to G5) and 14 buttons in one diode matrix behind two 74HC595 shift registers. | [HW] |
| Encoders | 7 quadrature encoders in the same matrix. | [HW] |
| Pots | MASTER on the ADC (PB6). The battery’s divider on PB1. | [HW] |
| LEDs | Key and button LEDs, multiplexed with the matrix columns. | [HW] |
| Audio | Stereo out through the chip’s ALNK0 (I2S) block, with four control lines to the output stage on PC0, PC1, PC2, PC6. Whether the converter is inside the chip or a separate codec is disputed: see Audio Output. | [CODE] [?] |
| MIDI | USB-MIDI device (USB 1.1 full speed); TRS MIDI in on UART1 (PH8). | [CODE] |
| USB | One USB port: device mode normally (stock firmware enumerates as 4C4A:C755); the chip’s mask-ROM download mode for recovery. USB host is possible with external power. | [HW] |
| Power | Battery with a charger; the core and SRAM supply (SYSVDD) and VDC14 set by firmware. See Clocks and Power. | [HW] |
| Debug | No debug header on the board. Recovery is over USB only. | [HW] |
Pin details: Pinout. Addresses: Memory Map.
The SMK-37
The SMK-37 Pro / Elite uses the same chip family with more keys, pads, faders and a different panel wiring. See SMK-37.
What runs on it from the factory
M-VAVE’s stock firmware is a DX7-compatible six-operator FM synth. V16 came out on 2026-10-21 (eight parts, 20-note polyphony, 64-step patterns, per awesome-fm-1 and the hub); before it, V15. M-VAVE replaces the file at its download address with each release, so that address now gives V16. Most custom-firmware installers and recovery tools were written against V15 (Recovery). [CODE] Reverse engineering of V13 found an msfa/Dexed-derived engine, a FreeRTOS-derived SMP kernel, JieLi’s UI, USB, BLE and storage stacks (FM-1-RE architecture). None of that is needed by a custom firmware: the open firmwares replace the whole application.
Sources
- JieLi AC79 SDK:
README.md(chip summary),include_lib/driver/cpu/wl82/asm/cpu.h(CPU_CORE_NUM). - felucca-bsp:
chip/fm1_clock.h,chip/fm1_sys.h,boards/fm1/. - m-bootloader SPEC.md §2, §8.
- FM-1-RE.
- Felucca-derived HAL headers (
hal/fm1_input.h,fm1_lcd_hw.h,fm1_adc.h,fm1_audio.h,fm1_uart.h; GPL-3.0-only, © Leo Kuroshita), as in DUB-1 and other Felucca forks. fm1_rescue.pyin Felucca-family trees (flash ID and chip key checks).- FM-1 resource hub REVERSE_ENGINEERING.md §1.1, §1.2 (part marking, package, flash part, from board photos and JieLi’s AC7911B datasheet; no licence declared, so summarised here, not copied).
- mvave-fm1 firmware skill §10 (USB ID
4C4A:C755seen on a stock unit, 2026-10-22). - awesome-fm-1 “Official” (V16, October 2026).
Unofficial community wiki. Not affiliated with M-VAVE or JieLi. Text under CC BY-SA 4.0; code excerpts keep their own licences (License). Facts are tagged [HW] [SDK] [RE] [CODE] [?]: see Home. Found an error? See Contributing. Home